UnderGround Information










UnderGround Information




     ///PAY TV DECODER PLANS///



         MATERIALS REQUIRED:



1   - Radio Shack mini-box ( #270-235)

1   - 1/4 watt resistor, 2.2k-2.4k ohm

      (RS #271-1325)

1   - 75pf-100pf variable capacitor

      (Hard to find)

2   - F61a chassis-type coaxial

      connectors (RS #278-212)

12" - No. 12 solid copper wire

12" - RG59 coaxial cable





         ///INSTRUCTIONS///





1.  Bare a length of No. 12 gauge solid

copper wire and twist around a 3/8"

nail or rod to form a coil of 9 turns.

Elongate coil to a length of 1 1/2"

inches and form right angle bends on

each end.



2.  Solder the varible capacitor to

the coil. It doesn't matter where you

solder it, it still does the same job.

The best place for it is in the center

with the adjustment screw facing upward



Note: When it comes time to place coil

in box, the coil must be insulated from

grounding.  This can be done by crazy-

glueing a piece of rubber to the bottom

of the box, and securing the coil to it.



3.  Tap coil at points 2 1/2 turns from

ends of coil and solder to coaxial

chassis connectors, bringing tap leads

through holes in chassis box.  Use as

little wire as possible.



4.  Solder resistor to center of coil

and ground other end of resistor to

chassis box, using solder lug and small

screw.



5.  Drill a 1/2" diameter hold in mini-

box cover to permit adjustment of the

variable capacitor from the outside.

Inspect the device for defects in

workmanship and place cover on mini-

box.  Tighten securely.



6.  Place device in line with existing

cable on either side of the coverter

box and connect to television set with

the short piece of RG59 coaxial cable.

Set television set to HBO channel.



7.  Using a plastic screwdriver (non-matalic)

adjust the varible capacitor until picture

tunes in. Sit back, relax, and enjoy!!!